Home Home > 2019 > 02
Sign up | Login

Archive for February, 2019

Voters Choose Two New Board Members and One Incumbent to openSUSE Board

February 16th, 2019 by

Christian Boltz aka cboltz, incumbent

The results are in and the Voting Members have chosen incumbent Christian Boltz aka cboltz, new Board Member Marina Latini aka deneb_alpha, and new Board Member Dr. Axel Braun aka DocB to fill the three vacant seats on the openSUSE Board for the next two years.

New Board Member Marina Latini aka deneb_alpha

Out of 446 eligible voters, 46 more openSUSE Members than last elections, only 231 — 6 fewer than last elections — chose to cast their votes, leaving last spring’s elections holding the record both for most ballots cast and largest percentage of Members who took enough interest in openSUSE to take the time to cast their votes.

Incumbent Christian Boltz aka cboltz garnered the most votes with a total of 141 votes — more than half of those who voted — confirming the Community’s confidence in him.  He was followed closely by Marina Latini aka deneb_alpha with 119 votes — also more than half of the active voters — and Dr. Axel Braun aka DocB with 104 votes, almost half.

As incumbent, Christian is already sitting on the Board and will continue his duties for his second two-year term.  Marina and Axel are expected to join him and take their seats for their first two-year terms sometime within the next couple of weeks.

New Board Member Dr. Axel Braun aka DocB

The runners-up in this tough-to-decide race included three other impressive Candidates:  Incumbent Sarah Julia Kriesch aka AdaLovelace with 98 votes, Vinzenz Vietzke aka vinzv with 78 votes, Nathan Wolf aka futureboy and CubicleNate with 54 votes, and Sébastien Poher aka sogal with 51 votes.  Unfortunately, only three seats were vacant, as these three people would also have been valuable additions to the Board.

Next Elections Expected Less Than a Year in Fall of 2019

The Elections Committee for the 2018-2019 openSUSE Board Elections — Ish Sookun, Edwin Zakaria, and Gerry Makaro — sincerely hope that the runners up will step up to run again in the next elections as two seats will be up for election, one for Simon Lees, who will be finishing his first two-year term, and the other to replace Gertjan Lettink, who will be ending his second two-year term on the Board.

Board Members can only hold two consecutive two-year terms under openSUSE rules.

The Elections Committee would like to thank all the Community Members who stepped up to the plate and performed their Membership Duties in order to support openSUSE, the Project, and the Community in this elections process.  You can find out more about the Elections and the Candidates at the Official Wiki Page.

 

Inkscape, GTK, glibc Updates Arrive in Tumbleweed

February 14th, 2019 by

A single snapshot was released this week for openSUSE Tumbleweed bringing update packages for Mozilla Thunderbird, dbus, Inkscape, Ruby, glibc, gtk and more.

The lone snapshot of the week was 20190209. ModemManager made the jump from version 1.6.14 to 1.10.0 and consolidated common tag names among all the supported plugins as well as provided a new tag to allow specifying flow control settings to use in serial ports. The Mozilla Thunderbird 60.5.0 package gave more search engine options in certain locations offering Google and DuckDuckGo available by default. The email client also added Thunderbird FileLink with WeTransfer to upload large attachments. Thunderbird Filelink provides support for online storage services and allows upload attachments to an online storage service and then replaces the attachment in the message with a link. General-purpose parser generator bison 3.3.1 removed support for the 32-bit C/C++ development system DJGPP. The compiler cache, ccache 3.6,  which speeds up recompilation by caching previous compilations, fixed a problem due to Clang, which is a C language family frontend for LLVM, overwriting the output file when compiling an assembler file and added support for GNU Compiler Collection‘s `-ffile-prefix-map` option. The 1.12.12 version update for dbus stopped a few memory leaks and added a couple patches. The epson-inkjet-printer-escpr 1.6.35 version added support for new printer models EcoTank ET-M1100 and Epson WorkForce ST-2000. GNU C Library glibc 2.29 added getcpu wrapper function, which returns the currently used CPU and NUMA node, and optimized the generic exp, exp2, log, log2, pow, sinf, cosf, sincosf and tanf functions. Cross-platform widget toolkit gtk3 3.24.5 implement gdk_window_present for Wayland, updated translations and refreshed the theme. The health-checker 1.1 package added new plugins for cri-o and kubelet. Users of the professional-quality vector-graphics application Inkscape can now use the 0.92.4 version; the new version improves preferences of the measuring tool when grids are visible and fixes a crash that would happen when a user does a Shift/Ctrl-click when handling shapes. Tumbleweed users will have 1.7x faster performance with Ruby 2.6 as the default as compared to Ruby 2.5. Other library packages updated in the snapshot were libosinfo 1.3.0, libsodium 1.0.17, libsolv 0.7.3, libstorage-ng 4.1.86 and libzypp 17.11.1.

Snapshot 20190209 is trending at a moderate rating of 86, according to the Tumbleweed snapshot reviewer.

First Phase for openSUSE Conference Talks Begins

February 13th, 2019 by

openSUSE is pleased to announce the first phase for accepting talks for the openSUSE Conference 2019 (oSC19) has begun.

A total of 80 talks were submitted during the call for papers, which began in late fall and ended Feb. 4. In total, there were 42 normal talks, two long workshops, four short workshops, 19 short talks and seven lighting talks submitted.

The review team rated all the submitted abstracts and selected 22 normal talks, two long workshops, four short workshops, 13 short talks and five lighting talks.

Speakers have been notified of their accepted talk and must confirm their talk by March 1. If a speaker doesn’t confirm their talk by March 1, the talk will be withdrawn and the next highest rated talks will be accepted to fill the slot as part of the second phase of the talk selections for oSC19. Phase 2 will run from March 2 to March 16. The schedule for the conference will be published shortly after Phase 2.

There are five tracks listed for the conference this year. The tracks are:

  • openSUSE
  • Open Source Software
  • Cloud and Containers
  • Embedded Systems
  • Desktop and Applications

The openSUSE Conference will take place at the Z-Bau in Nuremberg, Germany, from May 24 – 26.

Visit events.opensuse.org for more information about oSC19 or email ddemaio (@) opensuse.org.

Only a Few Days Left to Cast Your Ballot in the Board Elections

February 10th, 2019 by

Cast Your Votes While You Can!

Ballots Will Close This Friday for 2018-2019 openSUSE Board Elections

Ahmad Romadhon, left, with openSUSE Board Member Simon Lees at the openSUSE Asia Summit

With only a few days left to go in the Board Elections, openSUSE enthusiast Ahmad Romadhon would like to urge all openSUSE Members who have not yet voted to cast their ballots before voting closes Friday, February 15, 2019 at 12h00 UTC.

The Gajah Mada University Indonesian Literature student from Yogyakarta, Indonesia, has contributed a new Poster for the openSUSE Elections with this goal in mind, as a healthy Community depends entirely on the active participation of its Members.

The ballots were sent out last week for the voting process to choose three Board Members in the 2018-2019 openSUSE Board Elections from a total of seven top quality Candidates in the running.

Check Your Inbox

If you are an openSUSE Member, you should have received an email containing the elections url and your credentials to log in and cast your vote. If you did not receive this e-mail, and if you are a qualified Member, you must contact the Elections Committee immediately.

You may cast your vote until Friday, February 15, 2019. You may also update your vote within this time-frame should you wish to do so.  Qualified Community Members may vote for up to three out of the seven candidates whose biographies were published during the course of the Elections Campaign.

Not an Easy Choice, but it is Important to Choose Your Representatives

2018-2019 Election Poster contributed by Ahmad Romadhon

In this year’s Election, the voters are being asked to choose between a superb crop of seven quality Candidates with extensive credentials of Contributions to the openSUSE Project, and they can only select three of the seven, so it will be a difficult choice to make.

The Elections Committee would like to remind all openSUSE Contributors that a healthy Project is only possible if it has a robust roster of Members who participate in the Elections process, and it is especially important they cast their votes.  Only then can the Board be a true representation of what the Community and the Project want to help guide the current and future path of the organization.

Last spring, the elections included an impressive list of quality candidates in an election that was the longest election period in the history of the project elections, with 237 out of 400 Members voting: A record participation in percentage and actual numbers.

This year, the Elections Committee wants to exceed that record, but only you — as an openSUSE Member — can make that happen.

You can find out more about the Elections and the Candidates at the Official Wiki Page.

 

Major Version Updates of Bash, libvirt, OpenConnect Arrive in Tumbleweed

February 7th, 2019 by

Another three snapshots were released this week for openSUSE Tumbleweed bringing updates for ImageMagick, Mesa, Apache, Ceph, Flatpak Builder, Python and more. Plus, new major versions of Bash, glusterfs, libvirt and openconnect were updated this week.

The first snapshot of the week, 20190201, was a complete rebuild of the distribution and the snapshots released since have gradually improved in quality, according to the Tumbleweed snapshot reviewer.

The most recent snapshot, 20190205, brought support HEIC EXIF & XMP profiles with the minor version release of the graphics editing tool ImageMagick 7.0.8.25. The 18.3.2 version of the Mesa library and Mesa-drivers were updated, which provided a number of fixes for the RADV Vulkan drivers. The apache2 package was updated to 2.4.38 and the update lists the mod_lua module as stable. Fixed conflicting items in rule dialogs were fixed with the autoyast2 4.1.0 update. Ceph’s updated package had a fix for SignatureMismatchError in s3 commands. The support library used in the Xfce desktop exo 0.12.4 fix highlight rendering with GTK 3. The scalable, distributed file system glusterfs had a major update jump from version 4.0.2 to 5.3. The new version added several new management and standalone features and the dot three minor version provided a fix for Filesystem in Userspace (FUSE) client’s memory leak. The major release of openconnect 8.02 added Cisco-compatible DTLSv1.2 support. Another major version release was libvirt 5.0.0 that added support for Open vSwitch with the new feature for Xen. Other packages that were updated were the kernel firmware, gnutls, libstorage-ng 4.1.84, llvm 7.0.1, mercurial 4.9 and python-setuptools 40.7.2. The sysconfig package moved backward from version 0.85.0 to 0.84.3.

The 20190202 snapshot updated 10 packages and gave Tumbleweed users their second consecutive Kernel of the week. The Linux Kernel 4.20.6 replaced the 4.20.4 kernel that was introduced in the snapshot a day earlier. The new kernel addressed the network authentication protocol Kerberos to enhance performance and behavior regressions. The libyaml 0.2.1 package ported a bug fix from Perl binding and had a change to support static and dynamic libraries. There were multiple python packages that were updated and feature rich Remote Desktop Application remmina 1.3.2 provided a few fixes including cosmetic fixes and add a missing endpoint in an SSH error message.

(more…)

Voting Gets Underway for the 2018-2019 openSUSE Board Elections

February 5th, 2019 by

Cast Your Votes!

We have done our part:  Now, You do Yours!

2018-2019 Election Poster contributed by Aris Winardi

The ballots are out and the 2-week voting process to choose three Board Members in the 2018-2019 openSUSE Board Elections now gets underway, with a total of seven top quality Candidates running.

If you are an openSUSE Member, you should have received an email with the elections url and your credential to log in and cast your vote. If you did not receive this e-mail, and if you are a qualified Member, you must contact the Elections Committee immediately.  You may cast your vote starting now and until February 15, 2019. You may also update your vote within this time-frame should you wish to do so. The election ballots will close February 15, 2019 at 12h00 UTC.

Members may vote for up to three out of the seven candidates whose biographies were published during the course of the previous weeks.

You can find out more about the Elections at the Official Wiki Page.